Inspire V1 Outdoor RGB LED Tape Light (DISCONTINUED)





*Discontinued and replaced with Inspire V4 Outdoor RGB*
The Inspire V1 Outdoor RGB LED Tape Lights is IP67 rated and is the perfect solution to beautifully illuminate outdoor decks, stairs, pathways, and landscaping. It is completely encased in silicone and can be mounted anywhere using our rubber Outdoor Strip Channel (required and sold separately).
Note: Does not have a 3M VHB tape adhesive backing.
WARNING! Do not install the Inspire Outdoor LED Tape Light in water-filled areas where it may come into contact with humans (such as pools and spas). This is for liability reasons in the event the product is incorrectly installed.
Specifications
Part Numbers:
5 Foot Length: INSPIRE-W-RGB-24VDC-5FT
16 Foot Length: INSPIRE-W-RGB-24VDC-16FT
Colors Available: RGB Color-Changing
Power Consumption: 4.32 Watts/Foot
Input Voltage: 24V DC
Cut Length: Every 4 Inches
Max Run Length: 16.4 Feet
Coating: Silicone Coated and Injected
Product Board Color: Black
Connector: None. Seal cut-ends with included end caps & silicone
LEDs Per Foot: 18
Lamp Life: 50,000 Hours
Light Distribution: 120°
LED Chip: SMD 5050 RGB
Dimming: PWM using an RGB Controller
Mounting: Required to use the Outdoor Strip Channel
Roll Lengths: 5 Feet & 16.4 Feet
Certifications: ETL Listed (USA & Canada) & IP67
Dimensions WxH: 1/2″ x 3/16″
Operating Temp.: -22°F to 140°F (-30°C to 60°C)
Environment: Outdoor Wet
Warranty: 5 Year Limited
Where to use Inspire V1 Outdoor RGB:
Use to light up outdoor areas and features:
- Landscaping
- Outdoor Stairs and Railings
- Outdoor Fences, Walls, & Caps
- Outdoor Kitchens
- Wet-Location Architectural Accents
Compatible Accessories
Mounting & Wiring Accessories
- Outdoor Strip Channel:
#STRIPCHAN5FT-OUTDOOR-10MM - Low Voltage Junction Box:
#JBOX-1 - Low Voltage In-Wall Rated 4 Conductor Wire:
#WR-XXAWG-4C (18 AWG, 16 AWG, 14 AWG, & 12 AWG)
Drivers
25W, 60W, 100W, 150W, 200W, 240W, 320W, & 600W
25W, 60W, 100W, 150W, 200W, 240W, 320W, & 600W
Commercial RGB DMX Components
- RGB DMX STICK CU4 Controller (Single Zone):
#RGB-DMX-CONT-STICK-CU4 - RGB DMX STICK 3 Controller (10 Zones):
#RGB-DMX-CONT-STICK3 - RGB DMX Decoder:
#RGB-DMX-DECODER (Connect RGB LED tape light runs to an RGB DMX controller) - RGB DMX XLR to RJ45 Adapters:
#RGB-DMX-XLRM-RJ45 & #RGB-DMX-XLRF-RJ45 (Connect 3-Pin XLR to RJ45) - RGB DMX Terminator:
#RGB-DMX-TERM (Terminate the DMX signal in the last of 4 or more decoders)